Take the TP 17 / TP M / TP Multi to your lo-
cal recycling plant
or
send the TP 17 / TP M / TP Multi back to
your supplier or to SIKA.
14 Technical data
The technical data of customised versions may differ from the data in these instructions.
Please observe the information specified on the type plate.
14.1 Shared characteristics
Series
Characteristics
TP 17 …
TP 17 … S
TP M … S
Calibrator
Influence of the operating tempera-
ture (0...50 °C) to the accuracy
+/- 0,02 °C/°C
Resolution reference temperature
setting range
0,1 °C
Detection speed
130 ms
Display
Resolution
0,1 °C
0,01 °C (-9,99 … 99.99), sonst 0,1 °C
Display unit
°C or °F (optional)
Two-line display:
- Reference temperature
- Target temperature
4-digit, 7-segment LED, 7mm high
red = upper display, green = lower display
Display for sensor break
- - - -
Sensor break behaviour
the control is switched off
Excess temperature behaviour
temperature fuses interrupt the power supply if there is excess
temperature inside the housing
Electrical characteristics
Block temperature control
via PID-controller
Controller outputs:
- Heater control
- Cooler control
- Fan control
voltage output for control of the solid state relay (8 mA/ 8 VDC)
voltage output for control of the solid state relay (8 mA/ 8 VDC)
relay SPDT (8 A-AC1, 3 A-AC3 / 250 VAC) 100,000 switching cycle
Degree of protection
IP 20
Process variables
Operating temperature
0...50 °C
Moisture in the operating area
30...95 %rF (not condensing))
Transport and storage temperature
-10...60 °C
