SIIG US2265, Руководство пользователя

Страница: 22 / 48

Installation
3-1
Chapter 3
Installation
This chapter will guide you through the installation of the
USB 2.0+1394+UltraATA RAID into your computer.
3-1 Hardware Installation
General instructions for installing the card are provided below. If
needed, please refer to your computer’s reference manual for more
information.
Caution: Static Electricity Discharge may permanently damage
your system. To avoid possible static electricity discharge during
installation, please follow the guidelines below:
• Discharge any static electricity build up in your body by
touching a large grounded metal surface or the computer’s
case (if plugged in), for a few seconds.
• During installation, avoid any contact with internal parts.
Handle cards only by their external edges.
1. Turn OFF the power to your computer and any other
connected peripheral devices.
2. Unplug the power cord from the back of the computer.
3. Open your computer’s cover.
4. Remove the slot bracket from an available PCI slot.
5. To install the card, carefully align the card's bus connector
with the selected PCI slot on the motherboard. Push the
board down firmly, but gently, until it is well seated.
6. Replace the slot bracket's holding screw to secure the card.
7. Close your computer's cover and reconnect the power cord.
Note: Hold the board by its external edges only. Avoid touching
the components, connectors or pins.