SIIG US2265, Руководство пользователя

Страница: 15 / 48

User's Manual
2-4
2-3.1 RAID 0 (striping)
This RAID array to be used on New/Blank hard drives, do not
stripe an existing Windows installation.
1. As the BIOS boots press
F3 when prompted to enter
the RAID BIOS utility.
2. At the next screen press F2 to form a RAID set.
3. Press F1 to create RAID 0.
4. Choose the chunk size to be used in the RAID set
(64 is recommended).
5. Choose the number of drives in your stripe set.
6. Assign the drives to be used. For optimal performance,
alternate drives from seperate IDE
channels.
7. After all drives are entered, press Y to create the
RAID set.
8. Press ESC to exit the RAID BIOS and
boot your computer.
9. Continue with Fdisk and Format steps as if you are
installing a conventional hard drive.
2-3.2 RAID 1 (mirroring)
Use this section to mirror New/Blank hard drives.
1. As the BIOS boots press F3 when prompted to enter
the RAID BIOS utility.
2. At the next screen press F2 to form a RAID set.
3. Press F2 to create RAID 1. In a Mirrored RAID Set the source
drive needs to be equal to or smaller than the destination
drive. For optimal performance the source drive and
destination drive should be on separate IDE channels.
4. Answer N to Auto Setup.
5. Assign the Source drive, then assign the Destination drive.
6. Answer N when asked to Copy from Source to Destination.
7. Answer Y to Enable Auto-Rebuild.
8. When asked Are you Sure? , press Y to accept .