background image

-4-

Series MHE-BB

02.19.00

Moonlite LED

 High Output Emergency Light

With Battery Backup

1. See Fig 3. 

NOTE: Fixture weight is 13 lb

.  and screw anchors of suitable capacity must be used in 

ceilings. If using J-Box ensure that box is firmly secured in recess.  If not using J-Box install (2) Screw 
Anchors for #10 mount screws supplied, at  11” between centers. If using J-Box, install at 9 1/2” 
between centers.  

2. Proceed as for Surface Mount, from Step  3 to END.

Fig 3

Surface Mount

220  VFW Avenue, Grasonville, MD 21638

TEL: (410) 827-- 8300   Fax:(410)827- 8866

[email protected]    www.signtexinc.com

Signtex  Inc

LIGHTING

OPTIONAL J-BOX

SCREW ANCHORS

120/277 VAC
INPUT

G

L

N

11” CRS

9 1/2” CRS

MOUNT SCREW
POSITIONS

Содержание Moonlite LED MHE-BB Series

Страница 1: ...erformed by qualified personnel 4 Consult your local building code for approved wiring and installation 5 Do not use outdoors 6 Do not use this equipment for other than intended use 7 Do not let power cords touch hot surfaces 8 Mount and secure the fixture at a location and height to avoid ready access and tampering by unauthorized persons 9 The use of accessory equipment is not recommended by the...

Страница 2: ...hat edge of box is flush or just below finished ceiling surface NOTE Fixture weight is 13 lb Install drop wires when fixture is mounted on T Bar grids in drop ceilings 3 Route AC supply wiring into back box through KO s on top or sides of housing as shown Connect GROUND wire to 8 stud inside housing then trim BLACK and WHITE input output wires to approx 8 inside housing 4 Remove male half of AC lamp ...

Страница 3: ...ORE CONNECTING BATT PLUG CONFIRM AC SUPPLY IS ON IF NOT ON HIGH OUTPUT LAMP WILL LIGHT When AC supply is ON connect BATTERY PLUG 4 Remove Hanging Wire and place Lamp Assembly into position Confirm that PTT and LAMP wiring plugs remain clear of Lamp Assembly in cavity above circuit Board Insert 2 Trim Plate screws and tighten 5 Push BATTERY PLUG into cavity at side of battery 6 5 With AC power ON an...

Страница 4: ...in recess If not using J Box install 2 Screw Anchors for 10 mount screws supplied at 11 between centers If using J Box install at 9 1 2 between centers 2 Proceed as for Surface Mount from Step 3 to END Fig 3 Surface Mount 220 VFWAvenue Grasonville MD21638 TEL 410 827 8300 Fax 410 827 8866 sales signtexinc com www signtexinc com Signtex Inc LIGHTING OPTIONAL J BOX SCREW ANCHORS 120 277 VAC INPUT G ...

Отзывы: