Series MHE-BB
02.19.00
Moonlite LED
™
High Output Emergency Light
With Battery Backup
Wire Connections & Final Assembly
-3-
Rotate clamp into position and tighten #8 clamp screw.
Make sure battery connector is free of clamp.
2
Mate AC supply plug and push plug into space
next to PCB as shown.
3
Note orientation of Lamp Assembly and attach
to housing using hanging wire supplied.
HANGING WIRE
1
Connect LAMP and PTT PLUGS as shown. BEFORE
CONNECTING BATT PLUG CONFIRM AC SUPPLY IS
ON. IF NOT ON, HIGH OUTPUT LAMP WILL LIGHT.
When AC supply is ON, connect BATTERY PLUG.
4
Remove Hanging Wire and place Lamp Assembly into
position. Confirm that PTT and LAMP wiring plugs
remain clear of Lamp Assembly in cavity above circuit
Board. Insert (2) Trim Plate screws and tighten.
5
Push BATTERY PLUG into cavity at side of
battery
6
5. With AC power ON and battery connected, confirm that LED STATUS INDICATOR is illuminated
GREEN. Press the PUSH TO TEST switch button, lamp will illuminate as long as the button is held
down.
Full battery charge requires 24 hrs with AC power connected.
