Signode Tension-Weld BTS-16, Руководство по эксплуатации, частям и безопасности

Страница: 2 / 16

2
READ THESE INSTRUCTIONS CAREFULLY. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN
SEVERE PERSONAL INJURY.
GENERAL SAFETY CONSIDERATIONS
1. STRAP BREAKAGE HAZARD
Improper operation of the tool or sharp corners on the load can result in strap breakage during
tensioning, which could result in the following:
!
A sudden loss of balance causing you to fall.
!
Both tool and strap flying violently towards your face.
Failure to place the strap properly around the load or an unstable or shifted load could result in a
sudden loss of strap tension during tensioning. This could result in a sudden loss of balance causing
you to fall.
Read the tool's operating instructions. If the load corners are sharp use edge protectors. Place the
strap correctly around a properly positioned load.
!
Positioning yourself in-line with the strap, during tensioning and sealing, can result in severe
personal injury from flying strap or tool. When tensioning or sealing, position yourself to one side
of the strap and keep all bystanders away.
!
Using strap not recommended for this tensioner can result in strap breakage during tensioning.
Use the correct Signode products for your application.
2. TRAINING
This tool must not be used by persons not properly trained in its use. Be certain that you receive
proper training from your employer. If you have any questions contact your Signode Representative.
3. EYE INJURY HAZARD
Failure to wear safety glasses with side shields can result in severe eye injury or
blindness. Always wear safety glasses with side shields which conform to ANSI Standard
Z87.1 or EN 166.
4. FALL HAZARD
Maintaining improper footing and/or balance when operating the tool can cause you to fall. Do not use
the tool when you are in an awkward position.
5. CUT HAZARD
Handling strap or sharp parts could result in cut hands or fingers. Wear protective gloves.
6. TOOL CARE
Take good care of the tool. Inspect and clean it daily, lubricate it weekly and adjust when
necessary. Replace any worn or broken parts.
7. WORK AREA
Keep work areas uncluttered and well lighted.
Several types of strap can be used with this tool. Use the correct Signode products for your application. If
you need help contact your Signode Representative.
CUTTING TENSIONED STRAP
Use only cutters designed for cutting strap; never use claw hammers, crowbars, chisels, axes or similar
tools. Such tools will cause the strap to fly apart with hazardous force. Before using any Signode product,
read its Operation and Safety Manual.