Signode Tension-Weld BTS-16, Руководство по эксплуатации, частям и безопасности, Страница: 13 / 16

13
TOOL MAINTENANCE
GENERAL
1. Clean the teeth on the upper welding gripper and welding base with the special brush
provided.
2. Periodically clean the tool with compressed air.
3. Disassemble, clean and lubricate the welding and cutting mechanisms.
CUTTER INSERT SERVICE
The cutter insert of the BTS has two serrated cutting edges. Over time the cutter blade insert may
become worn. Use the instructions below to reverse the insert to use the other cutting edge. If
the blade has been previously reversed, it should be replaced with a new part. These instructions
can also be used for installing a new cutter insert.
!
Remove the battery cell from
the tool.
!
Remove the four M5x12 socket
head cap screws which secure
the front cover to the tool.
!
Remove the cutter holder from
the tool. The small
compression spring should
remain with the cutter holder as
it is removed.
!
Remove the two M3x6 socket
head cap screws which secure
the cutter insert. Rotate the
cutter insert 180
B
and reinstall
(or replace if new).
!
Clean any debris from the tool and apply a light coating of grease to the cutter holder.
!
Reinstall the cutter holder into the tool. Continue to reinstall the from cover.