Page 5 of 12 DocNo.DCP0001326 DSM 05/01/05 rev7
Installation
Unpacking
On receipt of the amplifier shipment, please inspect for any damage incurred in transit. If damage is found,
please notify your supplier and the transport company immediately. State date, nature of damage and
whether any damage was present on the shipping container prior to unpacking. Please give the waybill
number of the shipping order.
This equipment is only suitable for installation in a well ventilated 19 inch equipment rack. Bottom and top
ventilation holes must not be blocked and air must be allowed to circulate freely through the internal
heatsinks.
If several P2.200LSs are installed in one rack, at least one U of rack space must be left between each
amplifier.
The unit should not be placed in areas;
1
with poor ventilation
2
exposed to direct sunlight
3
with high ambient temperature or adjacent to heat generating equipment
4
with high humidity or dust levels
5
susceptible to vibration
Caution
To prevent electric shock do not remove the cover
AC power operation
Due to the size and inductance of the power transformer, depending on where in the cycle the power is
switched on, the inrush current that is drawn when this device is connected can be as much as 150 Amps!
It is therefore essential that mains power is only derived from an automatic soft start device such as SigNET’s
SOFT4.
Connect the a.c. power cord to any one of the four IEC amplifier power outlets as described in the SOFT4
manual.
The unit complies with BS415.
AC power cord
The wires in the mains lead supplied with the unit are coloured in accordance with the following code.
Green and Yellow
Earth
Blue
Neutral
Brown
Live
As the colours of the wires in the mains lead of this unit may not correspond with the coloured markings
identifying the terminals in your plug, please connect as follows.
Wire
Plug terminal
Green and Yellow
‘E’ mark
‘EARTH’ symbol mark
‘GREEN’ mark
‘GREEN AND YELLOW’ mark
Blue
‘N’ mark
‘BLACK’ mark
‘BLUE’ mark
Brown
‘L’ mark
‘RED’ mark
‘BROWN’ mark
Caution
To prevent electric shock do not remove the cover
