Signamax
065-1163 F series RS-232/422/485 to 100BaseFX Media Converter
Configuration
21
with other devices with the same defaults.
NOTE:
Prior to following the instructions listed below for
Remote Computer Login, ensure that a serial cable
connection between the media converter and remote
workstation exists.
Remote Computer Login
1. The default Login name is
“admin
” with no preset
password. After successful login, type the following
command line to change the device IP address in CLI
mode where
xxx
’s represent values between
0
and
254
and the user should enter their own IP address in this
form.
• telnet
xxx.xxx.xxx.xxx.
2. After entering the new IP address, the system will
confirm that the operation is successful.
NOTE:
Copy the new address down on a piece of paper. You
will need the address when you are going to use
Telnet or set up a data transfer/communication
connection.
WARNING:
IP addresses are unique! If an address
isn’t available, please contact the
appropriate authorities to apply for one.
3. After you log into the system, you will see a welcome
message on-screen.
