Chapter 4
SQM-242 Multi
4-1
4.0 Introduction
The SQM-242 Multi program extends the capabilities of the SQM-242 CoDep program
to include up to six SQM-242 cards. With the SQM-242 Multi program, you can monitor
up to twenty four sensors and control up to 12 source outputs.
On startup, the program displays the firmware revision of each card that is properly
installed. If an SQM-242 is installed, but no revision (e.g. Card 1: 2.00) is displayed,
then consult the card installation section of this manual.
Operation of the SQM-242 Multi program is very similar to SQM-242 CoDep. Refer to
the previous chapter for descriptions of the parameter settings and readings text boxes.
4.1 Operation
Send All:
Sends all of the stored parameters to the SQM-242 card(s) in preparation for
a Read command. Normally you will click “Send All” to initialize the card, then make
individual Sensor and Output setting changes as needed. Current settings are stored in
an INI file in the application directory on exit from the program.
