Rev 3 9/21/17
9
41110479
3
3: Set Up Your mangOH Red Hardware
In this chapter, you will set up your mangOH Red to begin developing applications.
A typical mangOH Red kit includes:
•
mangOH Red board
•
Pre-installed CF3 (Common Form Factor) module and cover, and release tool
•
micro-USB cables (2)
•
Antenna (main)
•
Antenna (diversity)—Included if the CF3 module supports LTE
•
Sierra Wireless micro-SIM
The following image summarizes the parts of the mangOH Red that you will set up when you follow the
instructions in
.
Important:
Do not start connecting components until told to in the instructions, otherwise you may
encounter problems later in the guide.
Connect CF3 USB port
on bottom side of board
Optionally, connect CONSOLE USB
Set jumper on Power
Header to select USB
Insert Sierra Wireless (or other) SIM card
in slot on bottom side of board to connect
Set dipswitches to proper
Optionally, attach the
diversity antenna
Attach the
main antenna to
positions for the tasks in
this guide.
to dev machine for
power and to log in to
the device.
port used for input
power supply.
port to dev machine to display
diagnostic messages.
be able to connect to
a mobile network.
for modules that
support Rx diversity
to a mobile network.
(connector beside
header pins)
