Sierra Wireless mangOH Red, Начало работы

Страница: 27 / 59

6.1: Connect To a Mobile Network
Rev 3 9/21/17 27 41110479
6. Set the target to use IPv4 addressing (this is required for use with AirVantage later in the guide):
# cm data pdp ipv4
7. Check the connection status:
# cm data
a. If "Connected" is:
· "no", and APN has a value—The mangOH Red is ready to connect to the network. Go to Step 8 on
page 28 .
· "no", and APN is blank—You must set the APN. Continue to the next step ( step b ).
b. If you need to set the APN for:
· A Sierra Wireless SIM—Enter the following command:
# cm data apn internet.sierrawireless.com
· Other SIM:
i. , Replace "<your apn>" with the actual APN in the following command:
# cm data apn <your_apn>
If you do not know the APN for your SIM:
i. Search the Internet for the APN for your Home Network Operator that you showed in Step 5 (for
example, search for "Rogers Wireless").
ii. Set the APN as described above.
c. Check the connection status again to make sure you set the APN correctly:
# cm data
Note:
The APN for the Sierra Wireless SIM is internet.sierrawireless.com.
Note:
If your mobile network operator uses different APNs for 3G and LTE, make sure to use the APN for the
correct network based on your CF3 module type. For example, the WP8548 is a 3G-only module that does not
support LTE—the APN for the network operator’s 3G network should be used.
Example response when
Not connected, APN is set
Example response when
Not connected, no APN