Sierra Wireless Airlink GX450, Руководство пользователя по оборудованию

Страница: 32 / 72

AirLink GX Series Hardware User Guide
32 4114008
· Power cable is connected to power (line or battery power)
· Power is turned on or that the battery is fully charged
· Ignition Sense (pin 3) is connected to the battery or power source (see
Connecting a DC Power Cable on page 34 for details)
For information on configuring the GX Series device, see Configuring AirLink GX
Series devices on page 47.
LED Operation
Power-up and Reboot
On power-up or reboot, all LEDs turn red, then yellow, then green. They then go
through a blinking sequence that ends with the Power LED green and all the other
LEDs off. Once the other LEDs resume their normal operating behavior, the
reboot is complete.
To reboot the device:
• In ACEmanager, click the Reboot button at the top right of the screen.
• Press and release the Reset button on the device (see Front Panel on
page 10). Do not hold the button down for more than a few seconds. (If you
hold it for 7–10 seconds, the device resets to factory default settings.)
LED Behavior
Table 2-3: LED Behavior
LED Color / Pattern Description
Power Off No power or input voltage
≥
36 VDC or
≤
9 VDC
Solid Green Device is connected to nominal power and is operating normally.
Flashing Yellow / Green Device has a GPS fix
Solid Yellow Device is entering low power mode or system low level boot.
Solid Red Device is not operational (failure or in low power mode).
Signal Solid Green Good signal
(RSSI
≥
-85 dBm)
Solid Yellow Marginal signal (-100 dBm
<
RSSI
<
-85 dBm)
Solid Red Poor signal (-110 dBm
≤
RSSI
≤
-100 dBm)
Flashing Red No signal (RSSI
<
-110 dBm)