Siemens SITRANS F TRANSMAG 2, Руководство по эксплуатации, Страница: 102 / 126

6.5 Control Values
6.5.1 Volt. Um
Volt. Uref Control value for magnetic field current
Control value for reference voltage
6.5.2 Volt. Usig Electrode differential voltage
6.5.3 Volt. Uel1 Control value for voltage between elec‐
trode 1 and medium
6.5.4 Volt. Uel2 Control value for voltage between elec‐
trode 2 and medium
6.5.5 Flow % Range 1,2 Actual flow in % of set full scale value
6.5.6 Sampl. Frequ. Actual measuring frequency (Approx. 2 x
magnetic
frequency)
6.5.7 Selftest
0 %
FS Display of internal control values of meas‐
uring electronics. Run self-test to update
(menu 2.4.1)
Zero
Gain (Result display of the
last self-test)
(xxxxxxxx)
(Current status
active/inactive) Triggered when select‐
ing menu 2.4.1
6.5.8 Service Info Coded service information (Info)
6.5.9 Digital Input 2 Status of the digital input under considera‐
tion of the set signal type (Actual status
active/inactive)
6.6 Zero Trim
6.6.1 Zero Flow Cor. Correction value for the zero point of the
flow measurement in m/s -1 ... +1 m/s
6.6.2 Start Correct. Start of zero calibration; The medium must
be at a standstill during
calibration! Cancel • Cancel
• Start
6.7 Trim Parameter Values in 6.7.2.4 can only be written if no
SmartPlug data can be read
6.7.1 Cal.factor User-specific calibration factor; the meas‐
ured flow value is multiplied by this factor
before output (affects all outputs, totalizers
and display) 1.0 0.5 ... 1.5
6.7.2 CFH 5
CFR
5
Calibration value for hydraulic reference
point at 1m/s
Calibration value for reference path 400
100
6.7.3 ZPH
5
Calibration value for
hydraulic zero point 0
Parameters
TRANSMAG 2 with MAG 911/E
102
Operating Instructions, 03/2021, A5E00102775-AC