3.4
Verificator software - sensor - magnetism
Test of magnetic properties in the sensor
The bar indicates how the test is progressing. Press ESC to cancel the test.
T3:3 Magnetism test
0% -##
-100%
Press ESC to cancel
Test of the magnetic properties finished
Press ESC to cancel the verification.
T3:3 Magnetism test
0% -################
-100%
Press ESC to cancel
Is only displayed if the SENSORPROM
®
unit installed does not contain fingerprint data.
Press GO to store magnetic properties data in the SENSORPROM
®
unit. This data is used as
reference data for future verifications.
Always make sure that the sensor is OK before pressing GO.
Press ESC to cancel the verification.
Update SENSORPROM®
(see manual)
Press GO to update
Press ESC to cancel
Is only displayed if the previous display was accepted by pressing GO.
SENSORPROM
®
unit is updated with the data about the magnetic properties.
Restarting transmitter
Update SENSORPROM®
Please wait...
Is only displayed if the measured „fingerprint“ is out of range.
Could be caused by a defective Verificator. See "On site trouble shooting".
E3:
Sensor Failed
Sensor:
Selftest Fail
Press ESC to cancel
Operating (hardware)
3.4 Verificator software - sensor - magnetism
SITRANS F M Verificator
Operating Instructions, 07/2019, A5E45134218-AB
13
Содержание SITRANS F M Verificator
Страница 4: ...Table of contents SITRANS F M Verificator 4 Operating Instructions 07 2019 A5E45134218 AB ...
Страница 6: ...Introduction SITRANS F M Verificator 6 Operating Instructions 07 2019 A5E45134218 AB ...
Страница 38: ...Technical Data SITRANS F M Verificator 38 Operating Instructions 07 2019 A5E45134218 AB ...