Siemens SINAMICS G110, Руководство по эксплуатации

Страница: 40 / 92

Commissioning 04/2005
SINAMICS G110 Operating Instructions
40
6SL3298-0AA11-0BP0
Note
The speed reading on the BOP is correct if a Siemens standard 4-pole 3-phase
induction motor is connected. Otherwise the motor rated speed has to be changed
(see Section 3.4.4 on page 46).
Warning and fault status
When the BOP is fitted, the fault number or warning number, which is in
parameters r0947 or r2110, will be displayed should a fault or warning condition
occur.
For further details, please refer to the Parameter List.
3.4 Advanced Commissioning
This section describes the advanced commissioning that allows the user to
optimally configure the inverter to their specific motor and application. It also
describes how to operate the SINAMICS G110 inverter in a specific mode.
The advanced commissioning requires the user to directly access the parameters
held within the inverter utilizing either a USS master (for example, a PLC), the
Basic Operator Panel (BOP), or the STARTER software as listed in Table 3-3 on
page 41.
Additional equipment may be required to operate the inverter in some modes. As a
consequence, several commissioning methods are offered to the user (see Table
3-4 on page 44).
3.4.1 Modes of Operation
The SINAMICS G110 inverter can be connected and operated in a variety of
modes. An overview is given in Table 3-3 on page 41. The modes are described in
detail in the following sections.
Note
The SINAMICS G110 inverter can be connected in more than one mode at any
time, for example, the BOP is attached, USS used and switches connected to
terminals.