Siemens SICAM Q100, Руководство по эксплуатации устройства, Страница: 163 / 376

8 Operation at Use of a PC
8.3 Configuration of the Device
163 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
8.3.5.2 Tariffs (TOU)
Default Settings and Setting Ranges
1)
In this case, the protocol Modbus TCP can control tariff 1 to tariff 6. Refer to the System Manual SICAM
Q100, chapter 2.2.7.18 Register 0154: Tariffs (read and write), order number E50417-C1040-C522.
2 )
This synchronization source can only control tariff 1 or tariff 2.
Parameterizing the Tariffs
To change the tariff setting, proceed as follows:
✧ In the navigation window of the
Energy management
menu click
Tariffs (TOU)
.
Figure 8-42 Configure Tab, Tariffs (TOU) Input/Output Window
✧ Select the parameter in the list box according to Table 8-11. After the parameterization click
Send
.
The parameter is transmitted to the device but not enabled yet (passive parameter set).
✧ If you do not want to make any additional settings, continue with the
Activation
of the device configuration
according to section
Activating the Set of Parameters
. If you want to change other settings, enter the
changes and then enable the device configuration as described in section
Activating the Set of
Parameters
.
Table 8-11 Tariffs (TOU)
Parameter Default Setting Setting Range
Synchronization source Protocol Protocol
1)
Binary input 1
2)
Binary input 2
2)