5/8
1 4 3
0
／
1
／
2
／
3
0
Special mode:
0: normal Mode
1: simply sewing mode
2: motor initial angle measurement (Do not remove the belt)
3: Automatically setting the pulley ratio by the CPU. (synchronizer is necessary
and the belt not removed)
1 4 4
0~31 0
Feedforward torque of motor:
0: normal functions
1-31: feedforward torque level
1 5 3
1
～
100 1
The proportion coefficient of the pieces counter
1 5 4
1
～
9999 1
Maximum pieces of the counter
1 5 5
0
～
4 0
Count mode selection (For Sewing Piece)
0: The counter is invalid
1: Count up by pieces. When count over, counter will be auto- reset.
2: Count down by pieces. When count over, counter will be auto- reset.
3: Count up by pieces. When count over, motor stops and the counter must be
reset by the external switch or the P key on the panel.
4: Count down by pieces. When count over, motor stops and the counter must
be reset by the external switch or the P key on the panel.
1 6 1
0
／
1
／
2
Direction of parameter transfer:
0: no action 1: from operation panel to controller 2: from controller to
operation panel.
1 6 2
1, 2
Restore factory setting
1 6 3
1, 2
Save current parameters as user-defined default parameters.
1 6 4
-
Password
2 0 3
5-359 10
Trimming output start angle TS (down needle position angle as the reference
point)
2 0 4
10-359 120
Trimming output end angle TE (Down needle position angle is the reference
and this value should be bigger than TS)
2 0 A
10-60 20
Motor torque improvement coefficient during trimming
2 1 1
5-359 25
Thread release output start angle LS (down needle position angle as the
reference point)
2 1 2
10-359 350
Thread release output end angle LE (Down needle position angle is the
reference and this value should be bigger than LS)
2 1 3
1-999 1
Thread release output start delay time T1 (ms)
2 1 4
1
～
999 10
Thread release output end delay time T2 (ms) after up needle position
2 1 5
0
／
1 1
Wiper function 0: disable 1: enable
2 1 6
1
～
999 10
Wiper output delay time (ms)
2 1 7
1
～
9999 70
Wiper output time (ms)
2 1 9
0
／
1 0
Thread clamp function 0: disable 1: enable
2 1 A
10-359 120
Thread clamp start angle
2 1 B
11-359 318
Thread clamp end angle
2 2 0
200
～
360 360
Stop position after trimming (motor can stop with a reverse angle)
2 3 1
0
／
1 0
Auto test mode: 0: stitches mode 1: time mode
