Troubleshooting
en
35
Fault
Cause and troubleshooting
The operation does
not start or is inter-
rupted.
Different causes are possible.
▶
Check the notifications that appear on the display.
"Displaying information", Page 15
Malfunction
▶
Call the after-sales service.
Appliance does not
heat up.
Demo mode is switched on.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and then on again.
2.
Switch off demo mode in the basic settings within approx. 5 minutes.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a
The appliance is checked and is ready to use.
The time is not dis-
played when the ap-
pliance is switched
off.
Basic setting has been changed.
▶
Change the basic setting for the time display.
Appliance door can-
not be opened.
The cleaning function locks the appliance door; lights up in the display.
▶
Allow the appliance to cool down until goes out in the display.
"Cleaning function 'Pyrolytic activeClean'", Page 29
The childproof lock locks the appliance door.
▶
Use the button to deactivate the childproof lock.
You can switch off the lock in the basic settings.
Home Connect is not
working properly.
Different causes are possible.
▶
Go to www.home-connect.com.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The drying function is switched on.
To prevent condensation from forming when the appliance is in microwave-only mode, the
appliance automatically switches on an additional heating element when it is set to 600 W
or 900 W. The cooking result is not affected by this.
▶
You can change the basic setting for the drying function during microwave operation.
‒
Observe the information on operating with microwave.
The interior lighting
does not work.
The LED light is defective.
▶
Call the after-sales service.
Maximum operating
time reached.
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch the appliance off and on again using . Reset and start
the operation.
2.
If you do not need to use the appliance, press to switch it off.
Tip:
To prevent the appliance from switching off when you do not want it to, set a cooking
time.
"Time-setting options", Page 16
Error code made up
of letters and num-
bers appears on the
display, e.g. E0111.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a
If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.