Siemens 7XV5662-0AB01, Инструкция по применению

Страница: 65 / 72

7XV5662-0AB01 English
C53000-B1174-C166-1 65
Example 4:
Parameter assignment of the CC–S
0
’s in a two ended leased line application with two
connections via a terminal programmes. To start the assignment the CC–S
0
must enter the
configuration mode. All parameters are listed in the next two tables 17 and 18.
Note: In opposite to a dialing line the parameter assignment of a leased line is easier. All
numbers are assigned by the communication switch so there is no need to assign any
number for the CC–S
0
’s. Futhermore the choice of “DIAL” or “ACCEPT” is not
necessary.
The communication link between the CC–S
0
’s and the S
0
–Bus is established by the
communication switch. As far as the CC–S
0
’s are connected to the S
0
–Bus the
transmission starts. In a leased line application any routing of the data is made by the
communication switch.
The routing from the D–channels to the fibre optic cables is also fixed. The B1–channel
is always routed to the FO1/LWL1 interface and the B2–channel is routed to FO2/
LWL2 interface.
Command Description
defa 1 resets all parameter to the state of delivery
aciomco 0
both B–Channel starts dialling after Reset/Power On or an
interruption of the communication
isdn 14 sets the ISDN–Protocol to leased line for both B–Channels
save save the assigned parameters into a resident memory
reset
restarts the CC–S
0
with the new assigned parameters
Table 17: Leased line CC–S
0
#1
Command Description
defa 1 resets all parameter to the state of delivery
aciomco 0
both B–Channel starts dialling after Reset/Power On or an
interruption of the communication
isdn 14 sets the ISDN–Protocol to leased line for both B–Channels
save save the assigned parameters into a resident memory
reset
restarts the CC–S
0
with the new assigned parameters
Table 18: Leased line CC–S
0
#2