2
Safety information
2.1
Intended use
The TiM2xx is an opto-electronic laser sensor that scans the perimeter of its surround‐
ings at a single plane with the aid of laser beams. The TiM2xx measures its surround‐
ings using two-dimensional polar coordinates based on its measurement origin. Scan‐
ning is performed across a 240° sector. The maximum scanning range of the TiM2xx is
10 m on light, natural surfaces with an object reflectivity (> 50 % (e.g. a white house
wall). The scanning range is 3 m in the case of dark surfaces with remission of > 10%.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
2.2
Improper use
Any use outside of the stated areas, in particular use outside of the technical specifica‐
tions and the requirements for intended use, will be deemed to be incorrect use.
•
The device does not constitute a safety component in accordance with the respec‐
tive applicable safety standards for machines.
•
The device must not be used in explosion-hazardous areas, in corrosive environ‐
ments or under extreme environmental conditions.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
WARNING
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
■
Device should be used only in accordance with its intended use.
■
All information in these operating instructions must be strictly observed.
2.3
Limitation of liability
Relevant standards and regulations, the latest technological developments, and our
many years of knowledge and experience have all been taken into account when com‐
piling the data and information contained in these operating instructions. The manufac‐
turer accepts no liability for damage caused by:
■
Non-adherence to the product documentation (e.g., operating instructions)
■
Incorrect use
■
Use of untrained staff
■
Unauthorized conversions
■
Technical modifications
■
Use of unauthorized spare parts, consumables, and accessories
With special variants, where optional extras have been ordered, or owing to the latest
technical changes, the actual scope of delivery may vary from the features and illustra‐
tions shown here.
2.4
Modifications and conversions
NOTICE
Modifications and conversions to the device may result in unforeseeable dangers.
SAFETY INFORMATION
2
8025019/190A/2020-08 | SICK
O P E R A T I N G I N S T R U C T I O N S | TiM2xx
7
Subject to change without notice
