SICK CLV 490 Series, Руководство по эксплуатации

Страница: 202 / 266

Chapter 10 Operating Instructions
CLV 490 Bar Code Scanner
10-36
©
SICK AG · Division Auto Ident · Germany · All rights reserved 8 009 993/O824/20-12-2004
Appendix
The application of the CMC 400, the changed function of the "Device Ready" and "Read Re-
sult" LEDs of the CLV as well as the remedy for errror messages describes the CMC 400
Operating Instructions (order no. 8 010 002, German/English).
10.3.2 Installation and electrical connection
The pin assignments/wire colors for the connection cables of the parameter memory are
shown in the following tables:
– Parameter memory no. 2 030 023: Table 5-5, Page 5-8
– Parameter memory no. 2 020 307: Table 5-6 and Table 5-7, Page 5-9
– Parameter memory no. 2 033 126/no. 2 033 127: Table 5-8 and Table 5-9,
Page 5-10
– Parameter memory no. 2 030 065/no. 2 031 034: Table 5-10 and Table 5-11,
Page 5-11
– Parameter memory no. 2 027 543: Table 5-13 and Table 5-14, Page 5-13
– Parameter memory no. 2 020 981: Table 5-17 and Table 5-18, Page 5-15
– Parameter memory no. 2 021 267: Table 5-19 and Table 5-20, Page 5-16
¾
Mount the parameter memory on the CLV as shown in Chapter 5.5.3 Connecting the
supply voltage, Page 5-19 and connect the cables to the CBD 420 or CDM 490 Con-
nection Module or to the non-SICK power supply.
10.3.3 Operation
The parameter memory in the connector cover connected to the CLV is accessed
•
using the selected CLV start option
•
after the parameters have been downloaded to the CLV with the permanent storage
function and the S
TART WITH
E
XTERNAL
P
ARAMETERS
option
The start option is set at the bottom right of the D
EVICE
C
ONFIGURATION
tab as shown in
Fig. 10-32 (grey frame). The S
TART WITH
E
XTERNAL
P
ARAMETERS
option is selected by default.
Fig. 10-33: CLV-Setup: "Device configuration" tab with the CLV start options