SICE SR 80, Инструкция по эксплуатации

Страница: 12 / 36

12
ENGLISH • Instructions manual
6.2 INSTALLING THE PLATFORM
1. Fit the anti-rotation rod onto the pin fixed to the platform ( see Fig. H ).
Fasten the components with a washer and a 12 mm diam. circlip ( see Fig. I ).
2. Connect the platform to the lifter arm with the 10 mm diam. pivot pin, fastening with the
anti-rotation plate and the VCEI M6X12 screw supplied.
6.1 FASTENING THE LIFTER
1. Remove the left hand side panel of the tyre changer
2. Remove the tyre changer pedal guard ( see Fig. C ).
Under the guard, there are 4 threaded holes for fastening the lifter and one larger diameter
hole for the compressed air line.
N.B.: The pedal guard is NOT used again as the lifter itself acts as protection.
3. Connect the 6-4 diam. 800 mm long pipe, supplied with the lifter, to the quick connector
at the back of the lifter ( see Fig. D ).
4. Insert the other end of the pipe through the hole at the front of the tyre changer.
5. Fasten the lifter to the tyre changer by tightening the four M8x16 screws supplied into
the threaded holes on the tyre changer ( see Fig. E ).
6. Snap fit the 3 holder trays into the holes on the top of the lifter ( see Fig. F ).
7. Apply the grey front adhesive label to the lifter ( 1, Fig. G ).
Affix the tyre changer identification label ( 2, Fig. G ) at the top of the grey label, and
affix the adhesive label indicating the pedal controls at the bottom of the grey label ( 3,
Fig. G ).
D
E
F
C
3
1
2
G
H
I
L
M