SIBS Fuso Canter, Руководство по ремонту

Страница: 37 / 41

MAN-059 8 FEB 2017
37
Figure 24: Spring cover bolt torque sequence.
49. Inspect all fittings for damage or corrosion and replace if necessary.
50. Install a new cassette seal into the outer housing.
51. Install a new housing o-ring into the outer housing.
52. Install the outer brake pads in the outer housing ensuring correct orientation.
53. Install a new v-seal onto the yoke.
54. Install the outer housing assembly onto the yoke.
55. Install the rotor onto the yoke spline ensuring correct orientation.
56. Using a suitable lifting apparatus fit the SIBS® brake unit over the pinion shaft.
57. Hold the brake rotor to prevent it from detaching from the yoke during assembly.
58. Lift outer assembly and align the yoke with the pinion shaft with the EMMA spring covers positioned towards the bottom
of the brake.
59. Once the brake is held by the pinion shaft, rotate the outer housing until the EMMA spring covers are positioned towards
the top of the brake.
60. Remove any rotor retaining devices once the inner and outer housings are as close to each other as possible.
61. Fit the 12x M10 bolts and torque to 50 Nm in sequence. Ensure each bolt is torqued twice.
Figure 25: Housing bolt torque sequence.