MAN-059
8 FEB 2017
28
4.
Bleed the park/emergency brake system:
a.
Twist and release the red E-stop button on the control unit.
b.
If the control system detects air in the system on first release, it will enter bleed mode
–
this is indicated by the
brake status light flashing green
–
system pressure will be limited to 100 psi.
c.
With the E-stop released, thoroughly bleed the brake system by opening and closing the park/emergency system
bleed nipples until the fluid runs through clearly with no air bubbles. Ensure the pump reservoir is topped up
regularly during the procedure.
d.
Once the system is bled, apply and then release the park/emergency brake again
–
if the system has been
sufficiently bled then the brake status light should be solid green with the brake is released.
Figure 18: Park/emergency brake bleed screws.
5.
Affix the SIBS®
caution label to the inside top corner of the windshield on the driver’s side.
6.
Complete a vehicle pre-start check.
7.
If the vehicle is to be used on public roads it will require approval for road use.
a.
All vehicles can be fitted with an aftermarket modification plate.
b.
Please contact ABT customer service for details regarding SIBS® equipped vehicles requiring approval.
Bleed screws
Содержание Fuso Canter
