- 24 -
3.2 Jumper Settings
Several hardware settings are made through the use of jumper caps to con-
nect jumper pins on the mainboard. Pin #1 is located at any corner of each
jumper, you just find a white right angle on the mainboard, that's pin 1#.
There are several types of pin1# shown as below:
3-pin and multi (>3) pin jumpers shown as following:
Pin #1 on the left:
Pin #1 on the top:
Pin #1 on the right:
Pin #1 on the bottom:
Jumpers with two pins are shown as for Close [On] or
for
Open [Off]. To Short jumper pins, simply place a plastic jumper cap over the
desired pair of pins.
Caution!
1. Do not remove the mainboard from its antistatic protective packaging
until you are ready to install it.
2. Carefully hold the mainboard by its edges and avoid touching its
components. When putting the mainboard down, place it on top of its
original packaging film, on an even surface, and components side up.
3. Wear an antistatic wrist strap or take other suitable measures to prevent
electrostatic discharge (ESD) whenever handleing this equipment.
1
1
1
1
1
