LABOKLAV Eco 80 / 135
User Manual
17
In the picture you find the maximum main menu, by giving the code 2000 you find the program
parameter point only.
Enter the point program parameters. Inside the submenu, go to the program you want to change.
Inside this submenu you can choose the program phase
that should be changed directly.
Change program parameters only if the result gives real
advantage! The preprogrammed sterilization cycles are
validated for empty chamber and full loaded chamber. For the
normal use the 10 preprogrammed cycles should be enough.
When all programs are configured you should run and test the program with empty chamber and
full loaded chamber to be sure the program parameters do not make problems in normal cycle run.
If there are doubts, you should make a full validation of the program.
Cycle progress
The program cycle is running fully automatically. The display shows the actual program cycle and
gives information what is the actual situation in the running program phase.
The successful finish of sterilization cycle will be displayed. In case of an incorrect cycle additionally
sounds an acoustic signal.
In the following the typical display are described:
The steam sterilizer is switched on; program P1 is
activated but not started. The device is ready for start. If
the door is closed, the device is preheating the steam
generator automatically.
Deaeration:
Gravitation
Steril.:
134°C 00:04:00
