SHOWTEC Hydrogen DMX MKII, Руководство пользователя

Страница: 10 / 24

Ordercode: 43151
Hydrogen DMX MKII
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Control Modes
There are 3 modes: Stand-alone (built-in programs)
Master/Slave
DMX-512 (4CH)
One Hydrogen (Built-in Programs)
01) Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Hydrogen is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see page 14-15 for more information about the built-in programs.
Multiple Hydrogens (Master/Slave Mode)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-pin XLR cable to connect the Hydrogens.
The pins: 01) Earth
02) Signal (-)
03) Signal (+)
Link the units as shown in fig. 3, connect a DMX signal cable from the first unit's DMX "out" socket to the
second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can use the
same functions on the master device as described on pages 14-15. This means that you can set your
desired operation mode on the master device and all slave devices will react the same as the master
device.
Multiple Hydrogens Master/Slave Set Up
Fig. 03
9