Shop-Vac 16LT Series, Руководство пользователя

Страница: 3 / 24

3
Questions? Visit Shop-Vac ® at www.shopvac.com or call 1-888-822-4644
Volts
Total length of cord in feet
120V
Ampere Rating
More Not More
Than Than
0 - 6
6 - 10
10 - 12
12 - 16
25 50 100 150
AWG
18
18
16
14
16
16
16
12
16
14
14
14
12
12
Not recommended
Table A
your appliance. Use only three-wire outdoor extension cords, which have
three-prong grounding-type plugs and three-pole receptacles which accept
the extension cord’s plug. When vacuuming liquids, be sure the extension
cord connection does not come in contact with the liquid.
noTe:
STATIC SHOCKS ARE COMMON IN DRY AREAS OR WHEN THE
RELATIVE HUMIDITY OF THE AIR IS LOW. THIS IS ONLY TEMPORARY
AND DOES NOT AFFECT THE USE OF THE APPLIANCE. TO REDUCE
THE FREqUENCY OF STATIC
SHOCKS IN YOUR HOME, THE BEST
REMEDY IS TO ADD MOISTURE
TO THE AIR WITH A CONSOLE OR
INSTALLED HUMIDIFIER.
unpAcking AnD SeT-up
1. Pull lid latches in an outward motion, remove tank cover and any accessories that may have been shipped in the tank.
2. Attach caster system following the instructions and illustrations in this manual
3. Attach tool holder following the instructions and illustrations in this manual.
4. Before replacing tank cover, refer to Dry Pick Up or Wet Pick Up Operation in this manual to ensure you have the proper filters
installed for your cleaning operation.
5. Replace tank cover, and apply pressure with thumb to each latch until it snaps tightly in place. Make sure all lid latches are clamped
securely.
6. Insert long machine hose end with locking-nut into inlet of tank and tighten. Do not over-tighten.
7. Attach the extension wands to the accessory end of the hose. Twist slightly to tighten the connection
(figure A).
8. Attach one of the cleaning accessories (depending on your cleaning requirements) on the extension wands. Twist slightly to tighten the connection
(figure A).
9. Plug the cord into the wall outlet. Your cleaner is ready for use.
i = on, o = off
noTe: Many more useful tools are available at your local dealer, or the Shop-Vac
®
Website.
A
cASTeR SySTem ASSemBLy
B
c
10. You will find four caster feet
(figure B),
four casters
(figure c),
and four screws with your wet/dry vacuum.
Assemble as follows:
11. With cord disconnected from receptacle and tank cover removed, turn tank upside down so that the bottom is facing up.
12. With tank drain facing you, take caster feet marked
with letter A and place in slots on left front and right
rear of tank also marked with the letter A
(figure
1).
A
A
A
A
13. Secure with screws provided
(figure 2).
B
B
B
B
A
A
3
4
5
14. Take caster feet marked with the letter B and place
on right front and left rear of tank also marked with
the letter B (figure 3).
15. Secure with screws provided
(figure 4).
16. Insert casters into feet by placing stem of caster
into holes provided. Apply pressure and twisting
motion until casters snap into place (figure 5).
B
17. Return tank to upright position.
2
1