Shop fox W1852, Руководство пользователя

Страница: 38 / 56

-36-
Model W1852 (For Machines Mfd. Since 11/17)
O
PE
R
ATIO
NS
Correct Incorrect
Figure.41. Correct and incorrect screw
types.
3.
Thread and secure faceplate onto headstock spindle
(refer to Installing.Faceplate. on Page.29 ).
— If wood screws cannot be placed in workpiece, face-
plate can be mounted to a backing block attached
to workpiece (see Mounting the Workpiece to a
Backing Block).
1.
Make backing block from a suitable size piece of
scrap wood.
. Note:. Faces of backing block must be flat and
parallel to each other, or uneven surfaces will cause
workpiece to spin eccentrically, causing unnecessary
vibration and runout. It is best to mount backing
block to faceplate and turn other surface flat prior
to mounting.
2.
Locate and mark center of workpiece and backing
block.
3.
Drill a
1
⁄
4
" hole through center of backing block.
4.. Look through hole in backing block to line up center
with workpiece and glue and clamp backing block to
workpiece.
Note:. Allow glue to cure according to
manufacturer's instructions.
5..
Follow
Steps 1–3 under Mounting.Workpiece.on.
Faceplate
(see
Page 35) to attach backing block to
faceplate.
Mounting.Workpiece.to.Backing.Block