Shop fox W1692, Инструкция по эксплуатации

Страница: 13 / 48

11
Handwheel
The handwheel and crank operate the chain-
driven leadscrews that raise and lower the
table to control the cutting depth.
To mount the handwheel and crank, do these
steps:
1. Install the key in the worm gear shaft and
s lide the handwheel onto the shaft.
2. Install and tighten the hex nut and washer
on the end of the shaft as shown in
Figure
6.
3. Thread the crank into the handwheel and
tighten to keep the crank locked in place.
Dust Hood
We strongly recommend connecting your planer
to a dust collection system for optimum planing
results and personal safety.
To install the dust hood, do these steps:
1.
Match the holes in the dust hood to the
tapped holes in the planer casting on the
outfeed end.
2.
Secure the dust hood with the (6) M6-1.0 x
12 hex bolts from the hardware bag, as
shown in
Figure 7
.
3.
Attach the dust hose to the dust port with
a hose clamp.
Figure 6. Installed handwheel and crank.
Figure 7.
Installed dust hood.
Hex Nut
and
Washer
ASSEMBLY