Shop fox W1692, Инструкция по эксплуатации

Страница: 17 / 48

15
Figure 12. Table mounting screws.
9. Raise the table up so the block barely
touches the head casting as shown in
Figure 13 .
10. Remove the block and place it between
the middle-rear of the head casting and
the table. If there is a gap or it will not fit
under the head casting, measure the
difference with a feeler gauge. If this
measurement is more than 0.002", then
the table needs to be adjusted from front
to back.
11. There are two methods to adjust the table
on your planer. The first is for adjustments
smaller than 0.016" and the second is for
adjustments larger than 0.016".
To adjust the table less than 0.016", do these
steps:
1. Loosen the table mounting screws and
lift/lower the table until the table and the
cutterhead body are parallel with each
other and the table is parallel with the
head casting from front to back.
NOTE: This adjustment may require some
trial and error. See
Figure 12 .
2. Adjust each column on both sides until the
table is properly set. While adjusting the
columns, tighten each screw after each
step to ensure accurate results.
To adjust the table more than 0.016", do
these steps:
On the underside of the table there is a
chain drive and five sprockets as shown in
Figure 13 . The four sprockets in the
corners control the movement of the table
columns. The fifth sprocket is the idler
sprocket that controls the chain tension.
1. Loosen the two bolts on the idler sprocket
bracket (as shown in
Figure 13
) to loosen
the chain so that each sprocket can be
rotated on its own. See
Figure 14
.
Table Mounting
Screws
Figure 13. Underside of table.
Figure 14. Understanding sprocket movement.
Idler Sprocket
Bracket
Idler Sprocket
0.016"
ADJUSTMENTS