Shinybow USA SB-5688CAK, Инструкция по эксплуатации

Страница: 28 / 32

Note :
Control the switcher
SPD : Speed
LINK : Ethernet link
RJ-45 Female 8P-8 Connector
ETHERNET SERIAL INTERFACE CONNECT A PC OR CONTROL SYSTEM VERSION COMPATIBLE V2.0
For a complete list of commands, please reference external document extended Ethernet Protocol Instruction Manual.
ETHERNET SERIAL INTERFACE
Pin Ethernet Reference
1 TXOP TX +
2 TXON TX -
3 RXIP RX +
4 NC
5 NC
6 RXIN RX -
7 NC
8 GND
ETHERNET TCP/IP PROTOCOL COMMANDS ( ETHERNET / RS-232 CONTROL DRIVER V2.0.1 )
*** The Ethernet port and RS-232 port cannot be used simultaneously. Any connection to the Ethernet Control port will disable
serial commands send to the RS-232 port.***
RS-232 SERIAL INTERFACE CONNECT A PC OR CONTROL SYSTEM. VERSION COMPATIBLE V2.0
For a complete list of commands, please reference external document extended RS-232 Protocol Instruction Manual.
RS-232 Configuration
RS-232 cable is a straight thru cable and not null-modem
Definition Pin Pin Definition
1 1 DCD
TX 2 2 RX
RX 3 3 TX
4 4 DTR
GND 5 5 GND
6 6 DSR
7 7 RTS
8 8 CTS
9 9 RI
RS-232
RS-232 PROTOCOL COMMANDS (RS-232 CONTROL DRIVER V2.0.1)
The ShinybowUSA switcher can be controlled via the TCP/IP serial control port to allow for interfacing to a PC, or similar third party control
system.
The serial communication parameters are 9600 baud, 8 bit, No Parity and 1 stop bit - this is often referred to as 9600 8N1. When the unit
recognizes a complete command it will perform the requested action - there is no delimiter character required.
26
ETHERNET & RS-232 SERIAL INTERFACE
PC
Shinybow
Device