Shinybow USA SB-5688CAK, Инструкция по эксплуатации

Страница: 19 / 32

17
EDID FUNCTION - SYSTEM RESET/FACTORY RESET
SYSTEM RESET
SYSTEM RESET RETURN SWITCH TO FACTORY DEFAULTS
Press
RECALL > OFF > ENTER RESET to Factory Default
1. Press
RECALL
button: The LCM will show the current stored presets status.
2. Press
OFF
button: The LCM will show “
SYSTEM RESET
”
3. Press
ENTER
button: To confirm entries.
The switch will reset all customizable values back to factory defaults.
You must POWER CYCLE the switch for the new values to take effect.
NOTE:
Factory Reset Defaults to:
1. Source Destination will be set to 1-1, 2-2, 3-3, etc.
2. Switch matrices stored in memory will be cleared.
3. Lock function will return to Un-Locked.
4. AUX function will disable and return to UN-AUX (On Select Models).
5. ARC function will disable and return to SPDIF as the Output (On Select Models).
6. EDID will return to FSS
®
(1080p-2ch Mode).
7. Ethernet port will return to DHCP=ENABLED.
RESET EDID
EDID RESET PROCEDURE
From the Front Panel:
Press
EDID > RECALL > OFF > ENTER
RESET EDID
Press EDID .
Press RECALL .
Press OFF . The display should show Reset EDID.
Press ENTER .
LEARNING MODE 2 SETTING EDID TO LEARNING MODE 2
Press
EDID > OFF > DESTINATIONS > ENTER
The EDID for HDMI has been passed from the
Destination port to the Source port.
1. Press EDID button: The LCM will show the current EDID status.
2. Press OFF button: Does the OFF button stay illuminated?*
*If Yes: Press ALL the Destination buttons individually so they illuminate blue.
The switcher will LEARN the destination HDMI EDID and pass to the selected
source. The switcher will Enable or Disable HDMI EDID for the selected source.
3. Press
ENTER to confirm changes. The LCM will return to the default screen
showing selected matrix routing status. This puts you in Learning Mode 2.
*If No: You might need a f/w update.