Shinybow USA SB-3403, Инструкция по эксплуатации

Страница: 38 / 56

36
SETTINGS
PROCEDURES TO CREATE CUSTOM DISPLAY MODES
1. Introduction
a. Users can create all kinds of custom display modes for regular, portrait
and irregular video walls with different sizes, resolutions and bezel LCD’s
at any angle and position through inputting the coordinates of the (2)
corners in each LCD-Top left and Top Right.
b. (4) LCD’s as one display unit can be cascaded without number
limitations. The display panel should be at 16:9 aspect ratio. Different
aspect ratio LCD’s require factory customization.
c. PiP/PoP function is still available in the custom modes created by the
user.
d. Due to some deviation among different panel brands, even using the
same size 16:9 panel, it is still necessary to check the results and fine-tune
the image position.
2. Collecting coordinates from a physical drawing.
a. Users can convert physical design drawings into 1920x1080 coordinates and pick up the coordinates at the Top Left
and Top Right corners in each LCD’s active display region, then input them to the SB-3403 through the OSD or PC tool
to get the result. The original point for the coordinate system is set at the Top Left corner as (0, 0).
b. Please note that the coordinate system (16:9) in the H&V directions should have the same scaling ratio. In the above
example, users can only take the horizontal to full scale but the vertical direction remains with some blanking borders.
Users can put the
“Video Wall” at the center position or close to the one edge. After the video wall is created, users can
use the [Ratio] and [Position] function to adjust aspect ratios and the final image position freely.
c. In above drawing, the coordinates for TV1 and TV2 are as follows:
• TV1 coordinates for the Top Left corner=(0, 586), Top Right corner=(366, 216)
• TV2 coordinates for the Top Left corner=(815, 635), Top Right corner=(447, 286)
•
Please pay attention to the display direction of the TV.