Shindaiwa DGW300MS, Руководство владельца и оператора

Страница: 19 / 40

- 16 -
“winterized” No.2-D (a blend of No.1-D and No.2-D). This blended fuel is usually
called No.2-D also, but can be used in colder temperatures than No.2-D fuel
which has not been “winterized”. Check with the services stations operator to be
sure you can get the properly blended fuel. Note that Diesel fuel may foam during
a fill-up. This can cause the automatic pump nozzle to shut off even though your
tank is not full.
Always use the fuel strainer.
Fill the fuel tank slightly less than the FULL tank.
6-4. Checking Fuel, Engine Oil and Water Leakage
Caution : Fire
Do not use this equipment when a leak is found. Repair the equipment before
use.
Be sure to check any leakage for fuel, oil and coolant/water at the hose connections
by opening side doors. Whenever checking any fuel leakage, turn the fuel lever
[OPEN] and be sure to close the fuel lever after checking.
6-5. Checking Battery
Caution : Injuries to eyes and skin
Battery fluid contains diluted sulfuric acid. Avoid contact with eyes, skin or
clothing.
If the acid comes to contact, especially with eyes, flush with a lot of water, and
contact your physician immediately.
Caution : Explosion
Do not use the equipment or charge the battery, in the case the battery fluid
level is lower than the LOWER level.
Battery may emit some combustible gas, so keep it away from fire and sparks.
①
Check the fluid level. If the level is near or lower
Than LOWER level, add distilled water until the fluid
level reaches UPPER level.
②
Make sure that the battery cables are firmly secured
to the posts. Tighten the clamps if necessary.
<Caution>
Make sure to turn to [OFF] the Battery Isolator
Switch before attempting to check the battery
terminal.
Check the specific gravity of the battery by The
hydrometer.
Recharge the battery If it falls below 1.23. Please
consult with our authorized distributor or service
dealers .
Replacing battery
①
Turn the Battery Isolator Switch to [OFF]
②
Remove the clamp and cable from negative [-]
post on the battery. (Remove always negative side first)
③
Remove the hold-down clamp from the battery.
④
Remove the clamp and cable from positive [+] post on the battery.
⑤
Remove the battery from the seat.
※
Reinstall a new battery in the reverse order.
(Install always the cable to the positive [+] post in the new battery first.)
<Caution>
Use the following battery. 46B24L
TERMINAL UPPER
LEVEL
LOWER
LEVEL
INS. CAP
[+] POST
HOLD-DOWN CLAMP
[-] POST
BATTERY
BATTERY ISOLATOR