Shindaiwa DGW300M, Руководство владельца и оператора

Страница: 29 / 36

- 26 -
①
Open the top plate.
②
Remove the radiator cap.
③
Loosen the water drain plug.
④
After draining all the water,
reinstall the water drain plug.
< Caution >
•
Change the packing, whenever changing
coolant/water.
•
Packing Part No.
：
6C090-58961 (Kubota)
⑤
Replace all the water in the sub tank.
⑥
Fill the radiator coolant/water up to
the MAX level (to the upper edge of
the inlet).
⑦
Reinstall the radiator cap.
⑧
Close the top plate.
< Caution >
•
After reinstalling the water drain plug tightly, keep the engine drive for a while to
check no water leakage and then stop the engine.
Danger : Electric Shock
•
Before performing any equipment check or maintenance, stop the engine,
and remove the engine key. A person performing the maintenance should
always keep the key.
Caution : Injuries
•
Before performing any equipment check or maintenance, stop the engine,
and remove the engine key. A person performing the maintenance should
always keep the key.
Caution : Fire
・
・ ・
・
Burns
•
When checking engine, always stop the engine, and keep far away from
fire. Temperature around muffler and exhaust can get extremely high. Wait
until the engine cools down, before performing any inspection.
If the equipment will not be used for more than two months, perform the following
maintenance and storage procedures.
①
Remove the battery.
②
Change the engine oil.
③
Drain fuel from the fuel tank, the fuel strainer.
④
Remove the engine key and save it.
⑤
Clean all parts, cover the generator/welder, and keep it in the storage, away
from dust and humidity.
< Caution >
•
Recharge the removed battery once a month.
12
． ． ． ．
Long-Term Storage
RADIATOR
CAP
TOP PLATE
WATER
INLET
SUB TANK
WATER DRAIN PLUG