Shindaiwa DGW200MS/UK, Руководство оператора

Страница: 20 / 36

- 19 -
8-3. Connection – Welding Cable
Danger: Electric Shock
Before connecting or disconnecting a welding cable from welding output
terminals, stop the engine, and remove the engine key. The person
performing this task should always keep the key.
①
Stop the engine.
②
Connect a welding cable to the
DINSE connectors, a welding rod
holder and a material holder.
<Caution>
Always fit the correct size DINSE
connectors.
( Recommended parts
：
DIX SK 35 or DIX SK 50 or DIX SK 70)
Ensure the welding cables connections are made correctly.
Be sure to connect the cable to welding output terminals securely. Otherwise,
welding output terminals may burn out by heat caused by poor connections.
Do not use a cable without the DINSE connectors. If you use a cable with the
insulation peeled off partly, to bind to an output terminal, the output terminal may
burn out by the heat caused by poor connections and a bare part of the cable may
touch the bonnet and short-circuit.
8-4. Duty Cycle
Duty cycle means the welding time ratio for 10 minutes. The duty cycle of the
equipment is 50%, namely, the welding time is 5 minutes or less in continuous 10
minutes. Be sure to take 5 minutes breaks after 5 minutes of welding.
<Caution>
The equipment may become damaged due to overheating, if welding for more than
5 successive minutes or a short break period.
This machine produces drooping characteristics to EN60974-1
WELDING ROD HOLDER
WELDING CABLE
DIN S E
CONNECTORS
MATERIAL HOLDER