Shindaiwa DGW200MS/UK, Руководство оператора

Страница: 16 / 36

- 15 -
6-4. Checking Fuel, Engine Oil and Water Leakage
Caution: Fire
Do not use this equipment when a leak is found. Repair the equipment before
use.
Be sure to check any leakage for fuel, oil and coolant/water at the hose connections
by opening side doors. Whenever checking any fuel leakage, turn the fuel lever
[OPEN] and be sure to close the fuel lever if a leak is found.
6-5. Checking Battery
Caution: Injuries to eyes and skin
Battery fluid contains diluted sulphuric acid. Avoid contact with eyes, skin or
clothing. If the acid comes in contact, especially with eyes, flush with a lot of
water, and seek medical attention immediately.
Caution: Explosion
Do not use the equipment or charge the battery, when the battery fluid level
is lower than the LOWER level.
The battery may emit combustible gas, so keep it away from fire and sparks.
Caution: Fire
Battery may emit some combustible gas, so keep it away from fire and sparks.
①
Check the fluid level. If the level is near or
lower than LOWER level, add distilled water
until the fluid level reaches UPPER level.
②
Make sure that the battery cables are firmly
secured to the posts. Tighten the clamps
if necessary.
<Caution>
Use a hydrometer to check the battery fluid. If specific gravity falls below 1.23, the
battery requires recharging.
Replacing battery
①
Remove the clamp and cable
from negative (-) post in the battery.
(Remove always negative side first)
②
Remove the hold-down clamp from
the battery.
③
Remove the clamp and cable
from the positive (+) post on the battery.
④
Remove the battery from the seat.
※
Reinstall a new battery in the reverse order.
(Always install the cable to the positive (+) post first.)
<Caution>
Use the following battery.
44B19L
INS. CAP
+ TERMINAL ○
- TERMINAL ○
HOLD-DOWN CLAMP
BATTERY