Shindaiwa DGK7F, Руководство владельца и оператора

Страница: 13 / 48

10
5. Equipment
5-1. Available Output Monitor
The available power generation capacity is shown on the digital display for each output power
supply. Use the display selector switch to display the values in the following order: single
phase three-wire U-W output, single phase three-wire U-N output, and single phase three-wire
W-N output. When the engine starts, the display always shows the single phase three-wire
U-W output.
< Note >

Consider the digitally displayed available output as an
approximate estimate. Be sure to thoroughly consider the
displayed value and the used load capacity when using a load
such as a motor with large starting capacity.
 If “- -” is displayed for the available output, it means that usage
has exceeded the rated capacity. Immediately stop the
equipment being used and reduce the load capacity of the
equipment.
5-2. Spill Containment
The bed of this generator is equipped with spill containment (structure for preventing
leakage of liquid) so that any spilled liquid will not leak to outside of the generator when oil or
fuel is spilled. Before starting operation, check if there is accumulated liquid in the spill
containment. Flush out any liquid that has accumulated.
(
Refer to section “8-4. Checking the Spill Containment” for inspection procedures. )
(
Refer to section “10. Inspection/Maintenance (9) Flushing Liquid in Spill Containment” for
flushing procedures.)
The generator is equipped with the following in order to prevent liquid from spilling in case you
forget to flush the liquid: The operation panel is equipped with an indicator that illuminates
when its sensor is triggered as the spill containment capacity accumulated enough liquid to
reach the about 3.4 gal. ( 13 liters ).
WARNING : INJURY

Do not open the inspection door when the starter switch is in the AUTO or
START position. It may get caught in rotating parts such as cooling fans and
fan belt.

Always turn the starter switch to the STOP position and stop the engine, then
close and lock OPERATION PANEL DOOR before checking or maintaining the
engine.
CAUTION : BURNS

Do not touch the engine and surrounding components immediately after
stopping the engine as they are still extremely hot.
CAUTION : FIRE

If fuel or oil is leaking, repair the leaking location before operating.
Display Selector Switch