Shindaiwa DGK7F, Руководство владельца и оператора, Страница: 15 / 48

12
(1) BATTERY (Insufficient Charging) Warning Indicator (Low Battery Voltage)
The BATTERY warning indicator illuminates and the engine automatically stops when
charging is not possible during operation. If this occurs, contact authorized distributor where
the generator was purchased.
< Note >

This battery charging warning indicator cannot detect battery deterioration or insufficient battery
fluid. (Refer to section “8-6. Checking the Battery”.)
(2) OIL PRESS (engine oil pressure) Warning Indicator (Low Oil Press.)
CAUTION: BURNS

Always be sure to stop the engine and allow the engine to cool when
performing inspection or maintenance of engine oil. Opening the oil level
indicator or oil filler cap during operation will result in hot oil gushing out.
If the engine oil pressure drops below 14 psi (0.98 x 100 kPa) during operation, the OIL
PRESS warning indicator illuminates and the engine will be automatically stopped. If this
occurs, check the engine oil level and add engine oil until it reaches the maximum level.
< Note >

This oil pressure warning indicator cannot detect oil deterioration. Change the engine oil
periodically. (Refer to section “8-1. Checking Engine Oil”.)
(3) WATER TEMP (Coolant Temperature) Warning Indicator (High Water Temp.)
CAUTION: BURNS

Do not open the radiator cap immediately after stopping the engine.
Doing so will result in hot steam gushing out.

Hot steam gushes out from the coolant sub-tank if the generator overheats.
Do not touch the coolant sub-tank.
If the coolant temperature rises above 239 °F(115
℃)
during operation, the WATER TEMP
warning indicator illuminates, and the engine will be automatically stopped. If this occurs, hot
steam will gush out of the coolant sub-tank. Check the coolant sub-tank coolant level after the
generator cools and add coolant to the coolant sub-tank if it is insufficient. (Refer to section
“8-2. Checking Coolant”.) If the coolant is at the specified amount, it is probable that the fan
belt is loose or there is a coolant leak. Wait for the engine to cool down and inspect for these
problems.
< Note >

The coolant temperature cannot be detected if the coolant level is excessively low. Always be sure
to check the coolant level in the radiator coolant sub-tank before starting operation.
(4) OVER SPEED (Engine Overspeed) Warning Indicator
This generator is equipped with a function such that the engine is automatically stopped if an
engine fault occurs causing the engine speed to increase excessively. If the engine speed
rose above 4,140 rpm during operation, the OVER SPEED warning indicator illuminates, and
the engine will be automatically stopped. If this occurs, it is probable that some malfunction
has occurred in the engine. Contact authorized distributor where the generator was
purchased.