Shindaiwa DG60MI, Руководство владельца и оператора

Страница: 40 / 52

37
Clip
Air Cleaner
Cap
Vacuator Valve
Air Cleaner Cap
Air Filter Elements
(3) Air Filter Element Cleaning/Replacement
Clean Every 200 hours
Replace Every 500 hours
Remove the air cleaner clips and cleaner cap.
Remove the element.
Clean or replace the element. Replace by
performing the above procedures in reverse
order.
< Note >

Always be sure to turn the cleaner cap in the direction
indicated by the arrow.

Replace the elements earlier if using in an excessively
dusty location.

Do not add oil as this generator uses a dry element.

Clear foreign material by pinching the vacuator valve once a week in normal operating
conditions or daily if operating in a location that is excessively dirty or dusty. Wipe away any
dirt or moisture that has adhered to the parts.

Never touch the elements for any reason except cleaning.

Element part no.: P828889 (ISUZU part no.)

Cleaning the air filter element
If dry dust is adhering : Blow comprgssed air from inside the element.
If carbon or oil is adhering : Replace with new parts.
(4) Draining Water from the Water Separator
Check Daily
Clean Every 200 hours
Set a container to catch spilled water.
Loosen the air bleeder plug of the fuel filter sufficiently.
Loosen the valve on the bottom to drain water.
Tighten the valve after drained the water.
■
Faucet tightening torque :
1.5 to 2.5N
･
m(0.15 to 0.25kgf
･
m)
Tighten the air-bleeding plug.
■
Air bleeding plug tightening torque :
8 to 12N
･
m(0.8 to 1.2kgf
･
m)
< Note >

After reset the plug and the valve, be sure to always start the engine and check that there is no
fuel leakage.

If water is accumulate in the cup, draining water from the fuel tank.(
Refer to section “
(7)
Draining Water from the Fuel Tank
”
.)

Be careful not to over-tighten the drain plug and air bleeder plug.

Always be sure to wipe up any spilled fuel.
4
3
2
1
3
2
1
Valve
Air Bleeder
Plug