Shindaiwa BP35, Руководство владельца/оператора

Страница: 7 / 20

7
BP3514
BP3515
ASSEMBL
Y
Adjust Throttle Cable Free Play
1. Test the throttle lever for smooth op-
eration. If any stiffness or binding are
noted, the cause must be identified
and corrected before the brushcutter
can be placed in service.
2. Test the throttle lever for proper “free
play” of approximately 7mm in the
idle position. See Figure 12. If neces-
sary, adjustments can be made at the
carburetor.
1. Temporarily move the adjuster cover
to expose the cable adjuster.
2. Loosen the cable locknut and then
turn the cable adjuster in or out until
proper free play is achieved.
See Figure 13.
3. Tighten cable adjuster locknut and
move adjuster cover back into place.
7mm Free
Play
BP35 Brushcutter
Checking Free Play Adjusting Free Play
Adjuster
Cover
Cable
Locknut
Cable
Adjuster
Figure 12
Figure 13
Install the Cutting Attachment Shield
Install the Cutting Attachment Shield.
1. Insert the cutting attachment shield
between the outer tube and the
cutting attachment shield mounting
plate. See Figure 14.
WARNING!
NEVER operate the unit without the
cutting attachment shield installed
and tightly secured!
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-
head cap screws.
NOTE:
It may be necessary to loosen the retain-
ing nut and clamp screw to adjust cutting
attachment shield mounting plate.
2. Fit the two shims and the bracket
over the outer tube and loosely
install the four socket-head cap
screws. See Figure 14.
Sub-Shield.
(when trimmer head is in use)
1. Attach the shield extension to the
cutting attachment shield.
WARNING!
NEVER use this machine without
sub-shield when using a trimmer head.
CAUTION!
Make sure the sub-guard is com-
pletely hooked at the hook receiver.
Sub-shield
Hook
Hook
Receiver
Cutting Attachment Shield
3. Tighten the four socket-head cap
screws to secure the cutting attach-
ment shield.
Figure 14
Line Cutter
Figure 14A
Hex
Screws
Socket-head
Cap Screws
Shim
Shim
Nut
Bracket
Cutting Attachment Shield
Outer Tube
WARNING!
The line cutter is very sharp. Wear
gloves to protect your hands when
handling.
To Change Position of Line Cutter.
1. Remove the 2 hex screws with a 4mm
hex wrench. See Figure 14A.
2. Rotate line cutter. See Figure 14A.
3. Reinstall the two hex screws and
tighten them securely.
NOTE:
Be careful to not lose the 2 nuts in the
cutting attachment shield, they are not
captured.
The line cutter can be positioned in
2 positions to obtain different line length
for cutting.
Cutting Attachment
Shield Mounting
Plate