62 Français
PROBLÈME
CAUSE POSSIBLE ET SOLUTION
DÉPANNAGE
Une poussière
blanche s’est
accumulée sur
le diffuseur de
vapeur ou au sol
sous l’appareil.
L’appareil et le disque ultrasonique ont besoin d’être nettoyés.
Voir la section NETTOYAGE.
L’eau est trop dure. Utiliser de l’eau distillée.
La télécom-
mande ne fonc-
tionne pas.
La pile est morte. Remplacez les piles par un pile 3V CR2032
neuve. Consultez les instructions de remplacement des piles à
la section TÉLÉCOMMANDE.
Pour que le produit capte le signal de la télécommande,
aucun obstacle ne doit entraver la portée optique de la
télécommande. Placez le ventilateur de façon que la lentille du
récepteur soit visible à partir de la télécommande.
7
English
-
Electric shock can occur when liquid comes in contact with electricity.
Be careful when removing the water tank and refilling to avoid electric
shock.
-
Turn the humidifier off if the relative humidity exceeds 60%. Humidity
levels above 60% may allow moisture to build up indoors and
condense on surfaces, where microorganisms can settle and grow.
For accurate readings, use a hygrometer which is available at most
hardware stores and home centers.
SERVICING WARNING—To reduce risk of fire, electrical shock and injury to
persons, observe the following:
-
Clean your product regularly, only as is instructed in this manual. Prior
to cleaning, turn off the power on your product and unplug. Do not
use gasoline, thinners, solvents, ammonias or other chemicals for
cleaning. Refer to the CLEANING instructions provided.
-
Do not open appliance housing while product is plugged in. To avoid
risk of shock, all service and/or repairs must be done by contacting
(833.800.8669) or ([email protected]).
-
Protect against the growth of mold, mildew and other microorganisms
by emptying the water tank immediately after each use. If water is left
in the tank for longer than 8 hours, thoroughly clean and disinfect the
unit as described in the section of this Owner’s Guide referenced as
CLEANING.
NOTE:
This equipment has been tested and complies with the CFR 47
Part 18 FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
These limits are designed to provide reasonable protection against
