Sharp ViewCam VL-E610S, Руководство по обслуживанию

Страница: 32 / 129

4-18
VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
In this state put the motor rotor on the upper surface of upper drum ass'y, and tighten the mounting screw. At this time
make sure that the head screw in the three places is visible through the motor rotor hole (Figure 8). The screw tightening
torque must be 0.1N·m (1 kg·cm).
(3) Lower drum ass'y
Tighten the FPC mounting screw to the lower drum ass'y. The screw tightening torque must be 0.08N·m (tighting torque
0.8kg·cm). (Figure 6)
(4) Upper drum ass’y
After fitting the gap shim which was removed when the upper drum ass'y was dismantled to the shaft of lower drum
ass’y, fit the upper drum ass’y. (Figure 3)
At this time slightly turn the upper drum ass'y by hand to ascertain that RTr does not scrape. If scrape is found, replace
the gap shim with the gap shim packaged together with the replacement upper drum ass’y.
(5) Drum motor stator
Fit the motor stator to the shaft. Then, apply the preliminary pressure 0.07N·m (0.7kg) to the motor stator, tighten the
stator mounting screw. The tightening torque must be 0.15N·m (1.5kg·cm).
Install the stator so that the chassis line is nearly parallel with the motor stator straight section when it is installed on
the chassis. (Figure 9)
(6) Drum base
Align the positioning pin, and tighten the screws (3 pcs.).
Alignment position (3 pcs.)
L ch
R ch
Motor rotor
Mounting screw
Upper drum ass'y
Head mounting
screw
Screw relief hole
Motor rotor
Upper drum ass'y
Rotor mounting screw
Rotary transformer
rotor ass'y
Figure 8
Figure 9
Motor stator
Stator set
screw
Motor stator
circuit board
Arrange parallel.
FPC
Chassis line