Sharp SW-180NC, Инструкция по эксплуатации

Страница: 65 / 126

4-33
Proper and improper stacking of workpieces
Proper Improper
Step 4 – Align the top clamp cylinders with the center of the workpiece and tighten the lock nuts.
Step 5 – Turn the top clamp handles so that the clearance between the top clamp jaw and the top of
the bundled workpiece is within 5 to 10 mm ( 0.2 ~ 0.4 in).
Step 6 – Press
Single/Bundle cutting mode button and switch to bundle cutting mode
.
Step 7 – For subsequent cutting procedures, refer to the cutting instructions above.
Uninstalling top clamp
Follow these steps to uninstall top clamp for cutting single material:
Step 1 – Disconnect the top clamp hoses.
Step 2 – Loosen the lock nuts and remove the top clamp.
Step 3 – Remove the stud bolts.
TERMINATING A CUTTING OPERATION
STOP

To terminate a cutting operation, press either the saw bow up button or the emergency stop
button.

The saw blade will stop running when the saw bow up button is pressed.

Both the saw blade and hydraulic pump motors will stop running when the emergency stop
button is pressed.

The machine will stop automatically when an error occurs. The error message will be shown on
the screen.