49
E
Mounting Precautions (For SHARP dealers and service engineers)
n
Attach the stand to the monitor
Caution
• The stand is for use in landscape orientation. It cannot be
used for portrait orientation.
1. Attach the stand rods (x2) to the VESA angle.
Put the VESA angle with the screw holes face up as below.
Attach the stand rods to the VESA angle, and secure it with
4 stand mounting screws (M3).
VESA angle
Stand rods
Screw holes
2. Attach the stand leg to the stand rods.
Flip the VESA angle and secure the stand rods and the
ends of stand leg with 4 stand mounting screws (M4).
Stand leg
3. Spread a thick, soft cloth (blanket, etc.) that will prevent
damage to the LCD panel on a stable flat surface where
the entire monitor can be placed, and place the monitor
with the LCD panel face down on the cloth.
Place so that the bottom of the monitor comes to the edge
of the table.
4. Attach the stand to the monitor.
Secure from the back with 4 stand mounting screws (M6).
n
Disassembling the stand
1. Spread a thick, soft cloth (blanket, etc.) that will prevent
damage to the LCD panel on a stable flat surface where
the entire monitor can be placed, and place the monitor
with the LCD panel face down on the cloth.
2. Remove the screws(x4) that fasten the stand, and
remove the stand.
3. Reverse the stand assembly procedure to disassemble
the stand.
