-26
Image Projection
▼
Keycode input box
Volume
buttons
STANDBY
button
ON button
Power
indicator
Lamp
indicator
INPUT
button
INPUT buttons
Volume
buttons
ON button
AV MUTE button
Basic Procedure
Connect the required external equipment to the pro-
jector before carrying out the following procedures.
Info
•
The language preset at the factory is English.
If you want to change the on-screen display to
another language, reset the language accord-
ing to the procedure on page
28
.
1
Plug the power cord into the wall
outlet.
•
The power indicator illuminates red, and
the projector enters standby mode.
2
Press
on the projector or
on the remote control.
•
The power indicator illuminates green.
After the lamp indicator illuminates, the
projector is ready to start operation.
Note
•
The lamp indicator illuminates,
indicating the status of the lamp.
Green:
The lamp is ready.
Blinking in green:
The lamp is warming
up or shutting down.
Red: The lamp should be replaced.
•
If the projector is put into the standby
mode and immediately turned on
again, the lamp indicator may take
some time to illuminate.
•
When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds af-
ter the power has been turned on, and
then transmit the commands.
•
When “Anti-Theft” (see page
48
) is set,
the keycode input box will appear. Enter
the keycode.
Note
•
When entering the keycode, press the
buttons previously set on the projec-
tor or the remote control.
•
For details about the Anti-Theft func-
tion, refer to “Anti-Theft (Setting the
Anti-Theft)” on page
48
.
PG-A10X-A_E_PDF_P26_31.p65
04.11.9, 11:04 AM
26
Содержание PG-A10X-A
Страница 74: ...SHARP CORPORATION ...
