Sharp Notevision PG-M25X, Руководство по эксплуатации

Страница: 15 / 131

Introduction
-11
Be sure to read the following safeguards when setting up
your projector.
Caution concerning the lamp unit
■
Potential hazard of glass
particles if lamp ruptures. In
case of lamp rupture, contact
your nearest Sharp Autho-
rized Projector Dealer or Ser-
vice Center for a replace-
ment.
See “Replacing the Lamp” on
page 111 .
Cautions concerning the setup of the
projector
■
For minimal servicing and to maintain high
image quality, SHARP recommends that this
projector be installed in an area free from
humidity, dust and cigarette smoke. When the
projector is subjected to these environments,
the lens must be cleaned more often. As long
as the projector is regularly cleaned, use in
these environments will not reduce the overall
operation life of the unit. Internal cleaning
should only be performed by a Sharp Autho-
rized Projector Dealer or Service Center.
Do not set up the projector in places
exposed to direct sunlight or bright
light.
■
Position the screen so that it is not in direct
sunlight or room light. Light falling directly on
the screen washes out the colors, making
viewing difficult. Close the curtains and dim
the lights when setting up the screen in a
sunny or bright room.
The projector may safely be tilted to
a maximum angle of 10 degrees.
■
Placement should be
within ±10 degrees.
Do not subject the projector to hard
impact and/or vibration.
■
Take care with the lens so as not to hit or
damage the surface of the lens.
Rest your eyes occasionally.
■
Continuously watching the screen for long
hours will make your eyes tired. Be sure to
rest your eyes sometimes.
Avoid locations with high or low tem-
perature.
■
The operating temperature for the projector
is from 41°F to 95°F (+5°C to +35°C)
■
The storage temperature for the projector is
from –4°F to 140°F (–20°C to +60°C)
Do not block the exhaust and intake
vents.
■
Allow at least 11.8 inches (30 cm) of space
between the exhaust vent and the nearest
wall or obstruction.
■
Be sure that the intake vent and the exhaust
vent are not obstructed.
■
If the cooling fan becomes obstructed, a pro-
tection circuit will automatically turn off the
projector. This does not indicate a malfunc-
tion. Remove the projector power cord from
the wall outlet and wait at least 10 minutes.
Place the projector where the intake and
exhaust vents are not blocked, plug the power
cord back in and turn on the projector. This
will return the projector to the normal oper-
ating condition.
Cautions regarding the transporta-
tion of the projector
■
When transporting the projector, be sure not
to subject it to hard impact and/or vibration,
as this can result in damage. Take extra
caution with the lens. Before moving the
projector, be sure to retract the antenna and
the eject button. Also, be sure to unplug the
power cord from the wall outlet, disconnect
any other cables connected to it.
CAUTION
PRECAUCI N
PR CAUTION
BQC-PGM20X//1
10
10