Sharp MD-R3, Руководство по эксплуатации

Страница: 38 / 48

(Continued)
●
The stop time setting display will appear.
●
The “hours” display will be automatically increased one hour.
■
Timer recording
Before timer recording, the following preparations are required.
●
Load a recordable MD.
1
While in the stop mode, press the TIMER button, and then
turn the jog dial until "TIMER SET" appears.
2
Within 10 seconds, press the ENTER button, and then select
"TIMER REC" using the jog dial.
3
Press the ENTER button.
●
The start time setting display will appear.
4
Enter the “hour”, using the jog dial. Then, press the ENTER
button.
5
Enter the “minute”, using the jog dial. Then, press the ENTER
button.
●
The stop time setting display will appear.
6
Enter the “hour”, using the jog dial. Then, press the ENTER
button.
7
Enter the “minute”, using the jog dial. Then, press the ENTER
button.
●
The start and stop times are now set.
8
Select the source program using the jog dial.
ANALOG
→
DIGITAL OPT
→
DIGITAL COAX
●
If you select the analog input, adjust the recording level. (Page
22)
9
Press the ENTER button.
Setting timer for recording:
1
Press the TIMER button, and then select "T-STANDBY" using
the jog dial.
2
Press the ENTER button.
●
The settings will appear in order, and the unit will enter the
timer recording stand-by mode. (The power will be turned off.)
Preparations for any equipment connected to this unit
Any equipment, such as a stereo, that is connected to this unit
should be set up in advance as follows:
●
Set it up so that music to be recorded will be played at the
same time as the timer’s start time.
ENTER DELETE/CLEAR
TIMER
REC LEVEL
MAX
MIN
5
4
3
2
1
AM
AM
AM
AM
AM
7
8
6
AM
AM
AM
When the digital optical input was selected
TIMER REC
2
1
Timer recording indicator
(Timer stand-by mode)
MD-R3
37